how to fix xbox one controller bumper

Introduction

This guide will teach you how to remove the buttons.

Remove the battery pack cover.

Remove the battery pack cover.
Remove batteries.

We recommend using a nylon spudger for this step. A metal spudger is shown. Grip the controller firmly to remove the side handles, wedging a spudger into the seam between the front and handle plates.

We recommend using a nylon spudger for this step. A metal spudger is shown.
Grip the controller firmly to remove the side handles, wedging a spudger into the seam between the front and handle plates.
Pry the side plate away from the front plate by moving the spudger back and forth. You will need to do this all the way around the side plate's seam.

There is a hidden screw located in the middle of the controller behind the label. Use a screwdriver and punch a hole directly in the center of the label.

There is a hidden screw located in the middle of the controller behind the label.
Use a screwdriver and punch a hole directly in the center of the label.
You may also lift the label if you do not want to puncture it.
Remove the five 10mm screws located on the back of the controller using the T8 Security Torx Screwdriver.

Remove the backplate.

Remove the backplate.

Remove the faceplate.

Remove the faceplate.

You may let the rumble motors hang freely out of their sockets. De-solder the soldered joints while holding the red and black wires down on the top motherboard.

You may let the rumble motors hang freely out of their sockets.
De-solder the soldered joints while holding the red and black wires down on the top motherboard.
De-solder the black and gray wires that are attached to the top motherboard.
Remove the rumble motors and set them aside.
Be careful while using the soldering iron not to damage other components or hurt yourself.
For information on how to solder, click here.

Unscrew the two 7mm T6 screws located near the rumble motor sockets.

Unscrew the two 7mm T6 screws located near the rumble motor sockets.

Firmly grip sides of motherboard near the middle.

Firmly grip sides of motherboard near the middle.
Lift upwards while slightly wiggling the motherboard forward and backward.
Lifting the motherboard will require some force.

Remove the six T6 Torx screws located on the bottom motherboard.

Remove the six T6 Torx screws located on the bottom motherboard.

Remove the bumpers by prying them off of the pegs that secure them, using a spudger. They are located on the front and back of the controller. A standard nylon spudger is recommended for this step. Using a metal spudger near the motherboard as shown risks damaging your device.

Remove the bumpers by prying them off of the pegs that secure them, using a spudger. They are located on the front and back of the controller.
A standard nylon spudger is recommended for this step. Using a metal spudger near the motherboard as shown risks damaging your device.

Lift the piece surrounding the Home button off of its pegs. Pry it off of the other side, using a spudger on the pins.

Lift the piece surrounding the Home button off of its pegs.
Pry it off of the other side, using a spudger on the pins.
A standard nylon spudger is recommended for this step. Using a metal spudger near the motherboard as shown risks damaging your device.
Removing this piece may require a lot of force.